/
q1 spec
Save to my account
Sign up
q1 spec
Flashcard Deck
Study
Untitled Flashcards
Study
1
Question
In this filter, any signals having frequency in-between cutoff frequencies are rejected.
Answer
Band-stop filter
2
Question
This type of embedded system is categorized according to scale.
Answer
[based on performance?]
3
Question
In this transducer selection factor, transducer shall maintain the expected input and output relationship as described by the transfer function to avoid errors.
Answer
errors
4
Question
In this type of filter, any signal with a frequency lower than the cutoff frequency gets blocked.
Answer
High-pass filter
5
Question
This is used to overcome the non linearity in the displacement sensor.
Answer
capacitive
6
Question
This converts the sensor output to suitable electrical form.
Answer
transduction element
7
Question
In this transducer, the measurand is converted into a change in electrostatic charge or voltage generated by crystals when it is mechanically stressed.
Answer
piezoelectric induction
8
Question
This material is used for room temperature applications.
Answer
[no answer yet]
9
Question
This is related failure and success measurement and it is normally associated with calibration.
Answer
repeatability
10
Question
This type of strain gauge has wire stretched that can be made of nickle,
Answer
unbonded strain gauge
11
Question
The experimental determination of the transfer function of actuator.
Answer
calibration
12
Question
This represents the slope of the transfer function.
Answer
[no answer yet]
13
Question
Which among the choices is not one of the transducers selection factors?Sensitivity, Cross Sensitivity, Reliability, Accuracy
Answer
Reliability
14
Question
This is the deviation of sensor's output at any given point.
Answer
hysteresis
15
Question
This is a functional computer system on a chip device that contains processor, memory, and programmable I/O devices.
Answer
microcontroller
16
Question
This system is related to a network to access the resources.
Answer
network embedded system
17
Question
The movement of the sensor element is used to cause a change in electrical voltage, resistance, capacitance, or mutual inductance.
Answer
contact sensors
18
Question
In this transducer selection factor, transducer shall not break down and maintain its input and output relationship under specified environmental condition.
Answer
environmental compatibility
19
Question
This is used as an additional processing unit for running the application in place of using embedded device.
Answer
ASSP (Application Specific System Processor)
20
Question
This transducer converts the mechanical elongation and compression into resistance change.
Answer
Strain gauge
21
Question
This is the extent to which the measured value might be wrong and normally expressed in percentage.
Answer
accuracy
22
Question
This is the drop rate of gain of the filter.
Answer
roll-off rate
23
Question
This is related failure and success measurement and it is normally associated with calibration.
Answer
repeatability
24
Question
This is used to convert desired parameter into electrically measurable signal
Answer
sensor system
25
Question
In this transducer, the measurand is converted into a change in electrostatic charge or voltage generated by crystals when it is mechanically stressed.
Answer
piezoelectric induction
26
Question
This indicate the range of the stimulus in which the device is usable.
Answer
frequency response
27
Question
In a passive filter, this has no gain. While in active filter, this may have gain depending on the configuration of the circuit.
Answer
passband
28
Question
This converts the sensor output to suitable electrical form
Answer
transduction element
29
Question
These frequencies are defined by the cutoff frequency of the filter.
Answer
passband and stopband frequencies